Íîâîñòè
| Overall results of “ROSUPACK 2008” exhibition. | |
|
“ROSUPACK 2008” exhibition is one of the biggest specialized exhibitions in Russia. This year it was held on June 23-27 in the exhibition centre “KROKUS-EXPO”. |
|
| in detail | |
| Complete web site renewal | |
|
In June, 2008, complete web page renewal of the “MELTPACK ” company was conducted and the navigation was changed. |
|
| in detail | |
| “MELTPACK” organization with limited liability becomes a participant of “ROSUPACK-2008” | |
|
“MELTPACK” organization with limited liability becomes a participant of “ROSUPACK-2008” exhibition which will be held on June 23-27 in the exhibition centre “KROKUS-EXPO” in Moscow. Our desk number is F14412 (pavilion ¹3, hall ¹14). |
|
| in detail | |
| New phone number | |
| The “MELTPACK” company informs that on the grounds of reconstructions and modernization of the phone network the numbers of company are transferred to the digital telephone station and switched from old code (495) to new one (499). Other numbers haven’t been changed. | |
| in detail | |
| The Âeardow Àdams company organized a conference between October 8-10 2008 in United Kingdom. | |
|
The Âeardow Àdams company organized a conference between October 8-10 2008 in United Kingdom. One of its peculiarities was that it was held in the oldest Cambridge university centre. The MELTPACK company became one of the participants in this event. |
|
| in detail | |
| Training courses at the “Business-master” corporation | |
|
One of the values of MELTPACK company is its constant improvement, including the improvement of their co-workers’ professionalism. |
|
| in detail |
“ROSUPACK 2008” exhibition is one of the biggest specialized exhibitions in Russia. This year it was held on June 23-27 in the exhibition centre “KROKUS-EXPO”.
In detail...
Prior to the 1970’s most manufacturer’s joints in corrugated box were either stapled or glued with a “pot and wheel” system. Since the advent of resin-based adhesives and closed, extrusion application systems, the possibility of running higher speeds with more accurate glue pattern placement became a reality. During the last 30 years, most of the systems installed were based on low-pressure adhesive system and a simple head that contacted that board, usually at an angle. The advent of faster direct-electric valves and further advances in adhesive technology have made jetting the glue from a distance away from the board a valid method for applying adhesives. Non-contact manufacturer’s joint glue application can offer advantages for corrugated converters, but also come with some downsides.
In detail...